Developing lightweight computation at the DSG edge

Commit 348cd4af authored by p4u's avatar p4u
Browse files

Added all devices for meshing (also LAN). Disabled niit option (not needed)....

Added all devices for meshing (also LAN). Disabled niit option (not needed). Changed default countrycode to UZ
parent 2e648cb9
......@@ -9,11 +9,11 @@ config 'qmp' 'interfaces'
# option 'configure_switch' 'eth0' # (uncomment line if available, e.g. WGT634U)
option 'lan_devices' 'eth0 wlan1' # will be used as is!
option 'wan_devices' 'eth1' # will be used as is!
option 'mesh_devices' 'wlan0 wlan2' # will be extended by vlan tag!
option 'mesh_devices' 'wlan0 wlan2 eth0 eth1' # will be extended by vlan tag!
config 'qmp' 'node'
option 'primary_device' 'eth0'
option 'community_id' 'qmp'
option 'community_id' 'qMp'
option 'community_node_id' ''
option 'key' '/tmp/qmp_key'
......@@ -33,8 +33,8 @@ config 'qmp' 'networks'
option 'dns' '141.1.1.1 85.126.4.170 202.83.95.227'
option 'lan_address' '172.30.22.1'
option 'lan_netmask' '255.255.255.0'
option 'publish_lan' '0'
option 'niit_prefix96' '0:0:0:0:0:ffff' # omit trailing 32 ipv4 bits !
#option 'publish_lan' '0'
#option 'niit_prefix96' '0:0:0:0:0:ffff' # omit trailing 32 ipv4 bits !
option 'mesh_protocol_vids' 'olsr6:1 bmx6:2' # means olsr6 use vlantag 10+1, bmx6 use vlantag 10+2
option 'mesh_vid_offset' '10'
......@@ -66,7 +66,7 @@ config 'qmp' 'tunnels'
config 'qmp' 'wireless'
option 'driver' 'mac80211'
option 'country' 'CT'
option 'country' 'UZ'
option 'bssid' '02:CA:FF:EE:BA:BE'
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment